Save your panicked pit guy a few seconds after a flame out…Tired of flimsy factory alignment pegs that move around at the worst time? Need your starter box SUPER easy to use for those unfamiliar with your gear? These universal starter alignment blocks funnel the chassis into position making alignment quick and easy.

Shown installed on a ProTek starter box. These are universal fit and we do not guarantee fitment for any starter boxes.

Install tips - Remove shocks and engine. Place car in position on the starter box. Slide the alignment blocks were you want them under the chassis plate. Be aware of any clearance issues on the bottom side of the lid(battery, motors etc). Use a NEW 3MM drill bit, twist it with your fingers to mark the holes for drilling using the alignment block as the guide for the drill bit. Drill holes and bolt down alignment blocks using provided hardware. YOU MAY NEED LONGER SCREWS depending on the lid thickness of your starter box. M3X12MM Hex caps screws, M3 low profile lock nuts and M3 washers included.

• INCLUDES -

• Qty. 4 ABS 3D printed Starter box alignment blocks

• Qty. 8 M3×12mm socket cap screws

• Qty 8 M3 low profile lock nuts

• Qty. 8 M3 washers